Industrial Wastewater Evaporator High Salt Wastewater Evaporation Crystallizer Garbage Permeate Liquid MVR Wastewater Evaporator is applied in traditional Chinese medicine,bio-engineering,waste liquid recycling, environment protecting, chemical, pharmaceutical and food industry to reach low temperature concentration. Especially the liquid with a slower increase of boiling temperature or dilute and easy to evaporate.
The Mechanical Vapor Recompressed (MVR) evaporator is composed of the following parts:
Pre-heater: Preheat the feeding liquid to be its evaporating temperature. It is usually tube type or plat type pre-heater that adopted
Heater: The feeding liquid evaporate after exchange heat with heating steam. Equip different type heater according to the property of liquid
Separator: To separate the second steam and liquid. Equip different type separator according to the property of liquid.
Vacuum system: Guarantee the vacuum degree of the whole system. Pump some air, uncondensable gas and gas that enters with liquid to keep a stable evaporation.
Pump: transport the feeding liquid and the condensed liquid. Equip different pump according to the property of liquid. There are centrifugal pump, screw pump and positive displacement pump to be used usually.
Cleaning system: there is CIP cleaning pipes to clean in place and it is easy to operate without dead angle. Because it may cause scaling as evaporation goes on.
Control system: through adjusting the motor speed, valve, flow meter, pressure, temperature and vacuum degree MVR control system guarantees automatic evaporation, cleaning, stopping .fault alarm, protection from damage and dynamic equilibrium.
Compressor system: It is centrifugal type steam compressed be used usually impeller of Compressor principal axis is driven by motor. The feeding steam is compressed into diffuser in the back of impeller under the centrifugal force. The feeding steam enter the middle dilute area of impeller. Fedding steam will be compressed into diffuser continuously as the impeller running. There are higher pressure and temperature for feeding steam because of the centrifugal force. Several pumps will be in series connection in order to reach required pressure and temperature.
Equipment features:
一Mechanical Vapor Recompression MVR Evaporator has the most advanced technique on the world. It requires little fresh steam (little steam is required at the beginning. the requires almost no fresh steam when normal running),This will cut the running cost greatly and reduce air pollution at the same time.
---With very close construction. it takes up 50% space of traditional evaporator only.
---The running cost that requires 25 -35kW power consumption to evaporate is very low compared with traditional evaporator.
---Comparing with traditional evaporator, there is very little temperature difference which guarantees gentle evaporation. increasing product quality and decreasing scaling. ---Continuous running. automatic operation. sate and eliable
---Simple process. practicability
---Reduce material staying time. increasing high product quality ---Save circulation water